WAGO Adds New IP67 Rated IO Link Analog Converters

Compact and economical, WAGO’s new IP67 rated I/O-Link Analog Converters offer a solid and cost-effective solution for incorporating conventional analog sensors and actuators with IO-Link communications.

The 765-2702/200-000 has two 0-10 VDC inputs that are converted to IO-Link for monitoring field level sensors. The 765-2703/200-000 has two 4-20ma analog outputs while the 765-2704/200-000 has two 0-10VDC analog outputs. Both devices will convert IO-Link signals to analog outputs and all of these devices can be set up using IO-Link configuration tools such as WAGO’s IO-Link configurator software.

These devices have an IO-Link communication interface that requires an IO-Link-capable module (IO-Link master) for interoperation. The IO-Link interface allows direct access to the process and diagnostic data and enables setting of the device parameters during operation.

Check out the available options below or contact us for assistance and availability.

	WAGO 765-2702/200-000 Datasheet Application: Decentralized preprocessing and conversion of analog signals This device is used for signal acquisition of a connected sensor or any other unit that has an analog output (0 … 10 V). The device has two analog voltage inputs.
	WAGO 765-2703/200-000 Datasheet Application: Decentralized preprocessing and output of analog signals This device controls a connected actuator or any other unit that has an analog input (4 … 20 mA). The device has two analog current inputs.
	WAGO 765-2704/200-000 Datasheet Application: Decentralized preprocessing and output of analog signals This device controls a connected actuator or any other unit that has an analog input (0 … 10 V). The device has two analog voltage outputs.