Schneider Electric ATV212HU15N4 Atv212 1,5Kw 2Hp 480V Tri Cem Ip20

(No reviews yet) Write a Review

Write a Review

Schneider Electric ATV212HU15N4 Atv212 1,5Kw 2Hp 480V Tri Cem Ip20

Rating Required Select Rating 1 star (worst) 2 stars 3 stars (average) 4 stars 5 stars (best)

Name

Email Required

Review Subject Required

Comments Required

SKU:

ATV212HU15N4

UPC:

3606480322457

MPN:

Condition:

New

Dielectric Strength:

3535 V DC between earth and power terminals || 5092 V DC between control and power terminals

Device Short Name:

ATV212

Reach Regulation:

Reference contains Substances of Very High Concern above the threshold

Warranty:

18 months

Electromagnetic Compatibility:

electrostatic discharge immunity test level 3 IEC 61000-4-2 || radiated radio-frequency electromagnetic field immunity test level 3 IEC 61000-4-3 || electrical fast transient/burst immunity test level 4 IEC 61000-4-4 || 1.2/50 µs - 8/20 µs surge immu

Option Card:

communication card LonWorks

Transmission Frame:

RTU

Electrical Connection:

VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES terminal 2.5-2.5 mm² / AWG 14 || L1/R, L2/S, L3/T terminal 6-6 mm² / AWG 10

Switching Frequency:

6...16 kHz adjustable || 12...16 kHz with derating factor

Transient Overtorque:

120-120 % of nominal motor torque +/- 10 % 60 s

Number Of Addresses:

1-247

Motor Power Kw:

1.5 kW

Environmental Characteristic:

classes 3C1 IEC 60721-3-3 || classes 3S2 IEC 60721-3-3

Assembly Style:

with heat sink

Physical Interface:

2-wire RS 485

Product Or Component Type:

variable speed drive

Product Specific Application:

pumps and fans in HVAC

Maximum Horse Power Rating:

2 hp

Power Dissipation In W:

78 W

Product Certifications:

UL || NOM 117 || C-tick || CSA

Speed Range:

45301

Motor Slip Compensation:

adjustable || not available in voltage/frequency ratio motor control || automatic whatever the load

Sampling Duration:

2 ms +/- 0.5 ms F discrete || 2 ms +/- 0.5 ms R discrete || 2 ms +/- 0.5 ms RES discrete || 3.5 ms +/- 0.5 ms VIA analog || 22 ms +/- 0.5 ms VIB analog

Analogue Input Type:

VIA switch-configurable voltage 0...10 V DC 24 V max 30000 Ohm 10 bits || VIB configurable voltage 0...10 V DC 24 V max 30000 Ohm 10 bits || VIB configurable PTC probe 0...6 probes 1500 Ohm || VIA switch-configurable current 0...20 mA 250 Ohm 10 bits

Air Flow:

27 m3/h

Relative Humidity:

5-95 % without condensation IEC 60068-2-3 || 5-95 % without dripping water IEC 60068-2-3

Prospective Line Isc:

5 kA

Pollution Degree:

2 IEC 61800-5-1

Depth:

150 mm

Functionality:

mid

Supply Voltage Limits:

323-528 V

Communication Port Protocol:

APOGEE FLN || BACnet || Modbus || LonWorks || METASYS N2

Apparent Power:

2.8 kVA 380 V

Maximum Transient Current:

4 A 60 s

Protection Type:

overheating protection drive || thermal power stage drive || short-circuit between motor phases drive || input phase breaks drive || overcurrent between output phases and earth drive || overvoltages on the DC bus drive || break on the control circuit

Braking To Standstill:

by DC injection

Width:

107 mm

Transmission Rate:

9600 bps or 19200 bps

Nominal Switching Frequency:

12 kHz

Speed Drive Output Frequency:

0.5-200 Hz

Ip Degree Of Protection:

IP20 on upper part without blanking plate on cover IEC 61800-5-1 || IP20 on upper part without blanking plate on cover IEC 60529 || IP21 IEC 61800-5-1 || IP21 IEC 60529 || IP41 on upper part IEC 61800-5-1 || IP41 on upper part IEC 60529

Emc Filter:

Class C2 EMC filter integrated

Analogue Input Number:

2

Data Format:

8 bits, 1 stop, odd even or no configurable parity

Weee:

The product must be disposed on European Union markets following specific waste collection and never end up in rubbish bins.

Linearity Error:

VIA +/- 0.15 % of maximum value input || VIB +/- 0.15 % of maximum value input || FM +/- 0.2 % output

Rohs Exemption Information:

Yes

Eu Rohs Directive:

Pro-active compliance (Product out of EU RoHS legal scope)

Operating Altitude:

3280.84...9842.52 ft (1000...3000 m) limited to 2000 m for the Corner Grounded distribution network with current derating 1 % per 100 m || <= 3280.84 ft (1000 m) without derating

Discrete Input Logic:

positive logic (source) F, R, RES), <= 5 V, >= 11 V || negative logic (sink) F, R, RES), >= 16 V, <= 10 V

Net Weight:

2 kg

Supply Frequency:

50...60 Hz - 5...5 %

Type Of Cable:

without mounting kit 1 IEC cable 45 °C, copper 90 °C / XLPE/EPR || without mounting kit 1 IEC cable 45 °C, copper 70 °C / PVC || with UL Type 1 kit 3 UL 508 cable 40 °C, copper 75 °C / PVC

Power Range:

1.1-2 kW 380-440 V 3 phase || 1.1-2 kW 480-500 V 3 phase

Acceleration And Deceleration Ramps:

linear adjustable separately from 0.01 to 3200 s || automatic based on the load

Vibration Resistance:

1.5 mm 3-13 Hz)IEC 60068-2-6 || 1 gn 13-200 Hz)EN/IEC 60068-2-8

Discrete Output Type:

configurable relay logic FLA, FLC) NO - 100000 cycles || configurable relay logic FLB, FLC) NC - 100000 cycles || configurable relay logic RY, RC) NO - 100000 cycles

Frequency Resolution:

display unit 0.1 Hz || analog input 0.024/50 Hz

Communication Service:

read device identification (43) || time out setting from 0.1 to 100 s || monitoring inhibitable || write single register (06) || read holding registers (03) 2 words maximum || write multiple registers (16) 2 words maximum

Type Of Polarization:

no impedance

Shock Resistance:

15 gn 11 ms IEC 60068-2-27

Mercury Free:

Yes

Operating Position:

vertical +/- 10 degree

California Proposition 65:

WARNING: This product can expose you to chemicals including: Lead and lead compounds, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov

[Us] Rated Supply Voltage:

380...480 V - 15...10 %

Insulation Resistance:

>= 1 mOhm 500 V DC for 1 minute

Maximum Switching Current:

5 A 250 V AC resistive cos phi = 1 L/R = 0 ms FL, R) || 5 A 30 V DC resistive cos phi = 1 L/R = 0 ms FL, R) || 2 A 250 V AC inductive cos phi = 0.4 L/R = 7 ms FL, R) || 2 A 30 V DC inductive cos phi = 0.4 L/R = 7 ms FL, R)

Accuracy:

+/- 0.6 % VIA) for a temperature variation 60 °C || +/- 0.6 % VIB) for a temperature variation 60 °C || +/- 1 % FM) for a temperature variation 60 °C

Standards:

EN 55011 class A group 1 || IEC 61800-3 environments 2 category C1 || EN 61800-3 category C3 || IEC 61800-3 || IEC 61800-3 environments 2 category C2 || IEC 61800-3 environments 1 category C3 || UL Type 1 || IEC 61800-3 environments 2 category C3 ||

Discrete And Process Manufacturing:

building - HVAC compressor for scroll || building - HVAC fan || building - HVAC pump

Ip Degree Of Protection:

IP21

Response Time:

FM 2 ms +/- 0.5 ms analog || FLA, FLC 7 ms +/- 0.5 ms discrete || FLB, FLC 7 ms +/- 0.5 ms discrete || RY, RC 7 ms +/- 0.5 ms discrete

Noise Level:

51 dB 86/188/EEC

Isolation:

electrical between power and control

Ambient Air Temperature For Storage:

-25-70 °C

Ambient Air Temperature For Operation:

-10-40 °C without derating) || 40-50 °C with derating factor)

Output Voltage:

<= power supply voltage

Connector Type:

1 open style || 1 RJ45

Marking:

CE

Minimum Switching Current:

3 mA 24 V DC configurable relay logic

Discrete Output Number:

2

Product Destination:

asynchronous motors

Height:

143 mm

Local Signalling:

for DC bus energized 1 LED (red)

Discrete Input Type:

F programmable 24 V DC level 1 PLC 4700 Ohm || R programmable 24 V DC level 1 PLC 4700 Ohm || RES programmable 24 V DC level 1 PLC 4700 Ohm

Phase:

3 phase

Analogue Output Number:

1

Network Frequency:

47.5...63 Hz

Speed Accuracy:

+/- 10 % of nominal slip 0.2 Tn to Tn

Supply:

internal supply for reference potentiometer (1 to 10 kOhm) 10.5 V DC +/- 5 %, <10 A overload and short-circuit protection || internal supply 24 V DC 21-27 V), <200 A overload and short-circuit protection

Motor Starter Type:

variable speed drive

Tightening Torque:

1.3 N.m, 11.5 lb.in L1/R, L2/S, L3/T) || 0.6 N.m VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES)

Torque Accuracy:

+/- 15 %

Line Current:

2.5 A 480 V || 3.2 A 380 V

Analogue Output Type:

FM switch-configurable voltage 0...10 V DC 7620 Ohm 10 bits || FM switch-configurable current 0...20 mA 970 Ohm 10 bits

Asynchronous Motor Control Profile:

voltage/frequency ratio - Energy Saving, quadratic U/f || voltage/frequency ratio, 5 points || voltage/frequency ratio, automatic IR compensation (U/f + automatic Uo) || voltage/frequency ratio, 2 points || flux vector control without sensor, standar

China Rohs Regulation:

X

Range Of Product:

Altivar 212

Specific Application:

HVAC

Regulation Loop:

adjustable PI regulator

Continuous Output Current:

3.7 A 380 V || 3.7 A 460 V